PCB0006 - RFM12 breakout

I made this simple little board so I could use the popular Hope RFM12 with a breadboard. This allows experimentation with the various FIFO modes and code to interface with the chip. Stray capacitance from the breadboard doesn't seem to have a huge effect, I was able to send and receive data just fine using a simple 1/4 wave antenna made from wire.

To enable reuse of the RFM12 module I found a connector that is the exact same pitch and spacing. It is made by Hirose DF11-12DS-2DSA and is available from Farnell (SKU 1688321). The LED is an optional indicator of module power.

Download

Download board (ZIP) - Eagle files

License

This work is made available under the Creative Commons Attribution-NonCommercial-ShareAlike (CC BY-NC-SA) liencse.

Attribution-NonCommercial-ShareAlike CC BY-NC-SA

Leave a Reply

Your email address will not be published. Required fields are marked *

*